Scheppach ETHT1000 Originalbetriebsanleitung Seite 30

18. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your product failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Product works with
interruptions.
Cutter bar becomes
hot.
Poor cutting results.
30 | GB
Possible cause
On/off switch defective
Motor defective.
Internal loose contact.
On/off switch defective
Cutter bar blunt.
Cutter bar has nicks.
Too much friction due to lack
of lubrication.
Cutter bar blunt.
Too much friction due to
lack of lubrication.
Dirty cutter bar.
Poor cutting technique.
www.scheppach.com
Remedy
Repair by an authorised service centre.
Repair by an authorised service centre.
Please contact our service department.
Check cutter bar, sharpen or contact our service
department.
Oil the cutter bar.
Check cutter bar, sharpen or contact our service
department.
Oil the cutter bar.
Clean the cutter bar.
Observe the working instructions.