Replacement Of Air Filter; Topping Up The Coolant; Period Of Inactivity - Mase Generators MPL 10 ASX Handbuch

GENERATORS
INFORMATION
For more detailed information about the fuel system,
read the motor use and maintenance manual.

6.4 Replacement of air filter

To ensure correct operation and long life of the motor,
periodically replace the air filter. A dirty filter can affect
motor power and produce excess fumes from the exhaust.
To replace the air filter cartridge, proceed as follows:
- remove the plastic cover of the air filter after removing
the fastening screws.
- replace the filter cartridge and correctly position the new
one.
- refit the cover and tighten up the screws.
WARNING
Replace the air filter every 300 hours of operation.
This interval should be shortened if the unit operates
in particularly dusty environments.

6.5 Topping up the coolant

Periodically check the level of the coolant in the exchanger.
To top up use a mixture of 50% water and 50% antifreeze
(AGIP ANTIFREEZE).
Access to the exchanger is through the upper door of the
soundproof casing fig.1 ref.8

6.6 Period of inactivity

If the power unit remains inactive for a long period,
proceed as follows:
- replace the oil in the sump
- replace the fuel filter
- remove the injector and put a few drops of oil inside the
combustion chamber. Manually turn the driving shaft a
couple of times. Refit the injector and close the intake
and exhaust.
OPERATIONS
Oil level check ......................................................... 1 0
Air cleaner cleaning ............................................... 1 0
Coolant level check ................................................. 1 0
Radiator gill check ................................................... 1 0
Oil change remplecement ................................... 125
Alternator belt stretch control ........................... 250
Oil filter replacement ............................................ 250
Fuel filter replacement ......................................... 250
Check cooling circuit sleeves ........................... 250
Alternator belt replacement ............................... 500
Setting rocker arms clearance .......................... 500
Brushes alternator check ................................... 500
Coolant replacement .......................................... 1000
Setting and injectors cleaning ......................... 1000
Partial overhaul ................................................... 2500
Total overhaul ..................................................... 5000
GB
6.8 Troubleshooting
The starter motor turns over but the main motor fails to
start
- Make sure there is fuel in the tank. (Replenish)
- Check the stop solenoid valve is powered (Consult
Service Centre)
- Check fuel pump operation (Consult Service Centre)
The control panel does not switch on after turning the
starter key
- Check the condition of the cutout fuses (Replace)
- Check the connection lead and all power connections.
(Reconnect)
- Check the condition of the battery (Recharge or replace)
The power unit stops during operation
- Check a cutout has not been triggered with lighting up
of relative indicator. (Remove cause and try to start the
unit again)
- Make sure there is fuel in the tank. (Replenish)
The motor runs irregularly
- Check fuel filters (Replace)
- Check operation of the fuel pump (Replace)
- Check the setting of the injectors (Consult Service
Centre)
- 38 -
MPL A - SX