Continuous Flow - WimTec LOFT Montageanleitung Und Bedienungsanleitung

EN
LOFT
Function description
Continuous fl ow:
DIP switch 3
Enable the continuous fl ow function to fi ll the washbasin or a container.
'ON' position = Continuous fl ow function is enabled.
'OFF' position = Continuous fl ow function is disabled (default setting).
Activate continuous fl ow:
Deactivate continuous fl ow:
|
22 Washbasin fi tting
1.
Approach the infrared sensor with your hand
(approx. 3 cm) and dwell - the water fl ow starts.
2. After the control LED fl ashes 3 times the continuous
fl ow will be activated for the set fl ush stop time.
Cleaning stop activated:
1.
Approach the infrared sensor with your hand
3 x
(approx. 3 cm) and dwell - the water fl ow starts.
2. After the control LED fl ashes 5 times the water fl ow
stops and the cleaning stop is activated for 3 min.
3. After further 3 times fl ashing the water fl ow starts again and
the continuous fl ow is enabled for the set fl ush stop time.
Automatic:
After the fl ush stop time has elapsed
(see time control, page 18).
Manual:
1.
To instantly end the continuous fl ow, approach the infrared
sensor with your hand (approx. 3 cm) again and dwell.
3x
2. After the control LED fl ashes 3 times the continuous fl ow
is disabled and the fi tting will resume normal operation.
WimTec LOFT
ON
OFF
1 2 3 4 5 6