Continuous Flow - WimTec OCEAN W6 Montage- Und Bedienungsanleitung

OCEAN W6
Program description

Continuous flow:

DIP switch 4
Enable the continuous flow function to fill the washbasin or a container.
DIP switch 4 ON = Continuous flow function enabled.
DIP switch 4 OFF = Continuous flow function disabled (default setting).
Enable continuous flow
Place your hand in front of
the infrared sensor (below
the thermostat knob) and
wait unit the icon begins to
pulse.
After blinking 3 times conti-
nuous flow is enabled for the
time set at the time control.
The illuminating icon lights up
continuously.
3 x Blinking
Enable continuous flow if
cleaning stop is enable
Place your hand in front of
the infrared sensor (below
the thermostat knob).
Water flow starts und the icon
begins to pulse. After blinking
5 times cleaning stop is ena-
bled and water flow stops.
Stay until 3 blink impulses
signal that continuous flow is
enabled.
5 x + 3 x Blinking
Wall tap control
Werkseinstellung:
ON
ON
OFF
OFF
1 2 3 4 5 6
ON
ON
OFF
OFF
1 2 3 4 5 6
ON
ON
OFF
OFF
1 2 3 4 5 6
ON
ON
OFF
OFF
1 2 3 4 5 6
Disable continuous flow
ON
The function automatically
OFF
1 2 3 4 5 6
ends after the time set at
the time control has elapsed.
You can manually disable the
function following the same
procedure used to enable it.
The fitting will resume normal
operation after you leave the
sensor range.
WimTec OCEAN W6
EN
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
29