Checking The Charge Status Of The Battery; Operation; Information On Sawing; General Information - Parkside Psssa 20-Li B2 Originalbetriebsanleitung

GB MT
• Do not expose the battery to direct sun-
light for long periods and do not place
it on a radiator (max. 50°C).
Charging the battery
1. Connect the battery charger (19) to a
power outlet.
2. Push the battery (16) into the charging
slot of the battery charger (19).
3. After charging, disconnect the battery
charger (19) from the mains.
4. Pull the battery (16) out of the battery
charger (19).
Checking the charge status
of the battery
1.
Press the button (18) next to the
charge level indicator (17) on
the battery (16).
The charge level of the battery is indic-
ated by illumination of the correspond-
ing LED lights.
red, orange, green
Battery charged
red, orange
Battery partially charged
red
Battery needs to be charged
2. Charge the battery (16) when only the
red LED on the level indicator (17) is il-
luminated.

Operation

Information on sawing

Selecting a stroke rate
The stroke rate can be adjusted in 6 steps
via the rotary wheel (7). Start with a low
stroke rate. As a rule of thumb:
Material
Hard
Soft
32
Stroke rate
Low
High
Selecting the pendulum motion
The larger the pendulum motion, the faster
your progress.
The optimal pendulum motion can be es-
tablished through practice; the following
settings are recommended:
• For thin material, hard material (e.g.
metal) or for cutting curves: Level 0
• Fine and clean cutting edges can be
achieved with little or no pendulum mo-
tion: Level 0 or 1.
• Soft material (wood, plastic, etc.): Level
0 or 1
Plunge sawing
Requirements
• Soft materials such as wood, aerated
concrete, plasterboard etc.
• Maximum stroke rate selected (level 6)
• Short saw blade mounted
Procedure (Fig. D)
1. Place the device with the front edge
of the footplate (8) on the workpiece.
The saw blade (9) does not touch the
workpiece.
2. Turn the device on. Wait until the max-
imum stroke rate has been reached.
3. Press the saw blade (9) into the work-
piece until the footplate (8) rests on the
workpiece.
4. Continue sawing along the cutting line.

General Information

• Before sawing the workpiece, check for
hidden foreign objects such as nails or
screws. These must be removed.
• Switch the appliance off immediately
if the saw blade jams. Force apart the
saw cut and pull the saw blade out
carefully.
• Always stand to the side of the saw
when working.
• Avoid over-stressing the device while
working.