Rothenberger ROFUSE TURBO S Bedienungsanleitung Seite 24

Settings 4/6
Language
 Then press the right-hand button to choose among the possible languages. Use the two
middle buttons to choose your language, which will be displayed on a dark background.
Then confirm this with the right-hand button.
Language
Englisch
Francais
5.7 Setting the parameters
 To set the welding parameters, after turning on the welding device, press the left button to
get to the basic settings menu, and then press the second button from the right four times.
The following notice appears on the display:
Settings 5/6
Parameter
 Pressing the right-hand button takes you to the password entry to be able to change the pa-
rameters. The password preset at the factory is 0000. With the two middle buttons, select
each individual digit, and confirm with the right-hand button. Then press the right-hand but-
ton often enough that the ☑ symbol appears. Then confirm again with the right-hand button
to get to the parameters submenu. The following submenus can be selected:
- Welder code
- Sleeve traceability
- Pipe traceability
- Owner
- Delete logs
- Password
- Weather entry
5.8 Setting the welder code
 In the parameters menu, the welder code submenu appears first. The right-hand button
takes you to the selection of whether the welder code should be active or inactive. With one
of the two middle buttons, make the desired selection, and confirm with the right-hand but-
ton.
Parameter 1/7
Welder Code
If you select the welder code in this menu, a valid welder code must be entered when entering
the welding parameters.
20
Deutsch
ENGLISH