Rothenberger ROFUSE TURBO S Bedienungsanleitung Seite 23

Date/Time
17.04.2023 14:27
 Press or hold down one of the two middle buttons (arrow up/arrow down) until the correct
day appears, and confirm with the right-hand button.
Repeat this process for the month, hours and minutes. As soon as the minutes have been se-
lected, instead of the right arrow, a tick appears in the display. If the minutes have been correctly
selected, press the right-hand button, and the correct date and time are adopted.
5.4 Setting the contrast
 To set the display contrast, after turning on the welding device, press the left button to get to
the basic settings menu, and then press the second button from the right. The following no-
tice appears on the display:
Settings 2/6
Contrast
 Then press the right-hand button to adjust the contrast.
Contrast
With the two middle buttons, you can change the display contrast to your preference and then
use the right-hand button to leave the submenu.
5.5 Setting the button tones
 To turn the button tones on or off, after turning on the welding device, press the left button to
get to the basic settings menu, and then press the second button from the right twice. The
following notice appears on the display:
Settings 3/6
Button tones
 Then press the right-hand button and use one of the middle buttons to chose whether you
would prefer to have the button tones on or off. Your selection is shown on a dark back-
ground. Use the right-hand button to confirm your selection.
Button tones
On Off
5.6 Setting the language
 To set the display language, after turning on the welding device, press the left button to get
to the basic settings menu, and then press the second button from the right three times. The
following notice appears on the display:
ENGLISH 19