Stanley pull-link AS-12PC Bedienungsanleitung Seite 3

1. General safety instructions and principles 1. General safety instructions and principles
Attention! Read all instructions and principles carefully. Every person installing,
operating or maintaining the tool must first be thoroughly acquainted with this
operations manual and is obliged to adhere to the following safety instructions
and principles:
> The tool must not be used for other purposes than for which it was designed.
> The tool must not be used in a different manner than recommended by the
manufacturer.
> Any alterations of the tool, its accessories or spare parts remain the sole
responsibility of the customer. After agreement the manufacturer provides
technical support in designing and making additional alterations.
> The tool must be kept in top condition and regularly tested for damage and
proper operation. The tool must be repaired only by an authorized technician
or by a person trained by the manufacturer or supplier. Should you have any
demand for training, please contact your sales agent.
> The tool must always be operated in accordance with respective sanitary and
safety regulations.
> All queries regarding proper and safe operation of the tool should be addressed
to your sales agent.
> Safety principles that must be adhered to in connection with operation of this
tool must be known to all workers who operate the tool.
> When handling the tool take extra care to avoid unwanted activation and
possible injury.
> The tool must be disconnected, during any kind of maintenance or repair,
from the compressed air source. [Replacing mandrels, pullers and/or anvils do
not apply]
> Before operating the tool always take up firm posture and steady position.
> Never aim the tool at another person.
> Always check that the vent holes are not blocked or covered and that the supply
hose is in good condition.
> Working pressure must not exceed 0.7 MPa.
> Oxygen or other flammable gasses from pressure cylinders must not serve as a
driving agent.
> When operating the tool it is recommended to use safety glasses and utility gloves.
> If the continuous cycle of riveting exceeds 8 hours per day, it is recommended
that the operators use ear protectors.
> When working with the tool the operator must not have loose parts of wear as
e.g. a tie, long hair, jewelry etc. to avoid getting caught by the tool.
> Same safety instructions apply for persons standing close to the tool.
AS-12PC
3