Chain Lubrication; Removing/Inserting The Rechargeable Battery; Operating; Switching On - Parkside Performance Ppksa 40-Li B2 Originalbetriebsanleitung

GB MT

Chain lubrication

The rail and chain must never be
without­oil.­If­the­cordless­chainsaw­
is­used­with­too­little­oil,­the­cutting­perfor-
mance and lifespan of the saw chain will
decrease as the chain will become blunt
more quickly. You can identify a case of
too little oil where smoke development or
discoloration of the rail occurs.
The chainsaw is equipped with an auto-
matic oiling system. As soon as the motor
is­speeded­up,­the­oil­also­flows­faster­to­
the­chain­bar­(7).
Switch off the device and remove
the battery before carrying out any
maintenance work.
Filling up with chain oil:
•­ Check­the­oil­fill­level­and­regularly­top­
up­with­oil­(10)­when­the­„minimum­
mark" is reached.
The "minimum mark" is the lower
line­of­the­oil­level­indicator­(10).­
The oil tank holds 180 ml of oil.
•­ Use a chain oil with a low content of
adhesive additives.
Chain oil and bio chain oil with addi-
tives to reduce friction and wear can
be purchased from our online shop.
•­ Empty­the­oil­tank­before­longer­peri-
ods­(6-8­weeks)­of­non-use.
1.­ Unscrew­the­oil­fill­cap­(9)­and­
fill­up­with­chain­oil.
2. Wipe off any spilled oil and
close the cap again.
Always switch off the device
and allow the motor to cool
before filling with chain oil.
50
There is a risk of fire if oil
overflows.
Removing/inserting the
rechargeable battery
1.­ To­insert­the­batteries­(16)­into­the­de-
vice,­push­the­batteries­along­the­guide­
rails­(23)­into­the­device.­You­will­hear­
them click into place.
2.­ To­remove­the­batteries­(16)­from­the­
device,­press­the­release­button­
16a)­on­the­batteries­and­pull­the­
(
batteries out.

Operating

Switch on the chainsaw only when
chain­bar,­saw­chain­and­sprocket­
chain wheel covering are correctly
assembled.
Make sure you have a secure stance. Be-
fore­starting,­ensure­that­the­electric­chain-
saw is in contact with no objects.
­ Caution!­Saw­can­oil­up,­see­notes­
on Operation startup.

Switching on

The device may only be used with
two batteries of the X 20 V Team
series from Parkside.
1.­ Place­the­batteries­(16)­into­the­device­
(see­"Inserting/removing­the­recharge-
able­battery").
2.­ Check­before­the­start,­
-­ whether­sufficient­chain­oil­is­in­the­
tank­and,­if­necessary,­refill­with­
chain oil (see Chapter Operation
Start).
- the charge level of the batteries.
3.­ Release­the­chain­brake,­where­you­