Charging The Battery; Assembly; Mounting The Saw Chain And Blade - Parkside Performance Ppksa 40-Li B2 Originalbetriebsanleitung

GB MT

Charging the battery

If­warm,­allow­the­battery­to­cool­be-
fore charging. Charge the battery
(16)­when­only­the­red­LED­on­the­charge­
level indicator (
1.­ If­necessary,­remove­the­batteries­(16)­
from the tool.
2.­ Slide­the­batteries­(16)­into­the­char-
ging slot of an­X 20 V Team­charger
from PARKSIDE.
3. Plug the charger into a socket.
4.­ Once­charging­is­complete,­disconnect­
the charger from the mains supply.
5.­ Remove­the­batteries­(16)­from­the­
charger.
Overview of the LED indicators on
the charger:
Green LED illuminated while battery not
inserted: Charger is ready.
Green LED lights up: Battery is charged.
Red LED lights up: Battery charging.
Red LED flashes: Overheated
Red and green LED flash:
Battery defective

Assembly

Always wear protective
gloves when working with
the chainsaw and employ only
original parts. Pull out the power
plug before doing any work on the
chainsaw itself – injury hazard!
Before putting the electric chain saw into
operation,­you­must:
-­ adjust­the­saw­chain­tension,
-­ pour­in­chain­oil,
charge and insert both batteries
-
- check the function of the chain brake
and the automatic oil pump.
48
24)­is­illuminated.
Mounting the saw chain
and blade
Switch off the device and remove
the battery before carrying out any
maintenance work.
1.­ Lay­the­saw­on­a­flat­surface.
2.­ Turn­the­fastening­bolt­(11)­anti-
clockwise (
sprocket­chain­wheel­covering­(13).
3.­ Spread­out­the­saw­chain­(6)­in­a­loop­
so that the cutting edges are aligned in
a clockwise direction. Use the symbol
below­the­chain­sprocket­(20)­as­a­gui-
de­to­align­of­the­saw­chain­(6).
4.­ Slide­the­saw­chain­(6)­into­the­bar­
guide groove. To mount the guide bar
(4),­raise­it­to­an­angle­of­approx.­
45 degrees. This will make it easier
to­replace­the­saw­chain­(6)­onto­the­
sprocket­(20).­
5.­ Place­the­chain­bar­(7)­and­saw­chain­
(6)­on­the­bar­bolts­(19).­When­the­pin­
(19a)­to­the­right­of­the­coach­screw­
(19)­sits­in­the­slotted­recess­on­the­
blade,­the­blade­is­placed­correctly.
It­is­normal­that­the­saw­chain­(6)­is­
slack.
6. Position the sprocket chain wheel cover-
ing­(13).­The­chain­tensioner­pin­(21)­
on­the­inside­of­the­sprocket­cover­(13)­
must be guided into the chain tension
pin­holder­(22).
7.­ Slightly­tighten­the­mounting­screw­(11)­
of the sprocket cover (
8.­ Pre-tension­the­saw­chain­(6)­by­turning­
the screw for the chain quick-tensioning
system­(12)­in­clockwise­direction.
9.­ Tighten­the­fastening­bolt­(11)­(
) to remove the
Direction of travel of the
saw chain
) .
).