Parkside Performance PABSP 20V Kurzanleitung Seite 18

NOTE
If the Lidl Home app cannot find available devices,
u
continue with "No automatic suggestion of available
devices".
No automatic suggestion of available devices:
1. Tap on the tab.
{Other}
2. Select in the bar on the left.
Select {Other-2}. The display flashes rapidly. The Lidl
3.
Home app scans the area for available devices.
4. Tap to select the battery pack
battery pack to the app.
Tap {Next}.
5.
Tap {Done}. The {Overview}
6.
is shown.
7. The information of the cordless drill "PABSP 20 Li C3
(2201)" can be found in
NOTE
Upgrading the firmware can change the features of the
u
Lidl Home app.
˜ Cleaning and care
m
WARNING!
Always switch the product off, remove the battery
pack and let the product cool down before
[ ]
performing inspection, maintenance and cleaning
work!
˜ Cleaning
Never allow fluids to get into the product.
o
The product must always be kept clean, dry and free from
o
oil or grease. Remove debris from it after each use and
before storage.
Regular and proper cleaning will help ensure safe use and
o
prolong the life of the product.
Clean the product with a dry cloth. Use a soft brush for
o
areas that are hard to reach.
In particular clean the air vents after every use with a cloth
o
and soft brush.
The vents must always be clear.
o
NOTE
Do not use chemical, alkaline, abrasive or other
u
aggressive detergents or disinfectants to clean this
product as they might be harmful to its surfaces.
18 GB
and to add the
[ ]
page of the battery pack
{Device info}.
˜ Maintenance
Before and after each use, check the product and
o
accessories (e.g. accessory tools) for wear and damage.
If required, exchange them for new ones as described in
this instruction manual. Observe the technical requirements
(see "Technical data").
˜ Repair
This product does not contain any parts that can be repaired
by the user. Contact an authorised service centre or a similarly
qualified person to have it checked and repaired.
˜ Storage
Push the rotation direction switch
o
to lock the on/off switch
Clean the product as described above.
o
Store the product and its accessories in a dark, dry, frost-
o
free, well-ventilated place.
Always store the product in a place that is inaccessible
o
to children. The ideal long term storage (longer than
3 months) temperature is between +20 and +26 °C.
Guide the drill bit into the bit holder
o
Store the product in its carrying case
o
Battery pack advice
Only store the battery pack
o
battery pack should be charged to 40 to 60 % (red and
orange LED in the charge indicator
storing for extended periods.
Check the battery pack
o
when storing for extended periods. Recharge as necessary.
˜ Transportation
Push the rotation direction switch
o
to lock the on/off switch
Transport the product in its carrying case
o
Protect the product from any heavy impact or strong
o
vibrations which may occur during transportation in
vehicles.
Secure the product to prevent it from slipping or falling
o
over.
˜ Disposal
Before passing on, disposing of or returning the product to
the manufacturer, make sure that all data has been deleted
from the product and the cloud.
To do this, refer to the chapter:
"Additional functions", menu point:
{Disconnect and wipe
Packaging:
The packaging is made of environmentally friendly materials,
which may be disposed of through your local recycling facilities.
to the centre position
[ 5 ]
.
[ 6 ]
.
[ 8 ]
.
[ ]
partially charged. The
[ ]
light up) before
[ ]
charge about every 3 months
[ ]
to the centre position
5 ] [
.
[ 6 ]
.
[ ]
data}