Parkside Performance PABSP 20V Kurzanleitung Seite 16

Before operating the product, check whether the accessory
o
tool is correctly positioned, i.e. centred in the chuck
Screw bits are labelled according to their dimensions and
o
their shape. If you are uncertain, always check whether the
bit fits tightly in the screw head without any free play.
˜ Operation
˜ Gear selection
m
ATTENTION! RISK OF PRODUCT DAMAGE!
Do not operate the gear selector
product has come to a standstill.
Change the gear by sliding the gear selector
o
or backwards (fig. F).
1 gear:
st
Suitable for:
Speed:
Torque:
2 gear:
nd
Suitable for:
Speed:
Torque:
˜ Setting the rotating direction
m
ATTENTION! RISK OF PRODUCT DAMAGE!
Do not operate the rotation direction switch
until the product has come to a standstill.
Change the direction of rotation by pressing the rotation
o
direction switch towards the left or right (fig. G).
5 ] [
When the rotation direction switch
o
position, the on/off switch
˜ Torque control
This product is equipped with a torque control that disengages
the spindle when a predefined torque is exceeded.
The torque can be adjusted by turning the torque sleeve
o
(fig. H).
Small screws or soft materials: Select a low level.
o
Large screws, hard materials or removing screws: Select a
o
high level.
For drilling operation: Turn the torque sleeve
o
position.
16 GB
.
[ 1 ]
until the
4 ] [
forwards
[ 4 ]
Screwing
Low
High
Drilling
High
Low
5 ] [
is in the middle
[ 5 ]
is locked.
[ 6 ]
to the
[ 3 ]
˜ Switching on and off
NOTE
The on/off switch
[ 6 ]
Switching on: Press and hold the on/off switch
o
Regulate the speed as required (see "Speed control")
(fig. I).
Switching off: Release the on/off switch
o
˜ Speed control
By using the on/off switch
o
control the speed:
Pressure
Gentle pressure:
Greater pressure:
˜ LED work light
This product is equipped with a LED work light
the immediate working area to improve visibility in poorly lit
areas.
The LED work light
o
the product is switched on.
NOTE
The LED work light
u
approx. 10 seconds after switching off the product.
˜ Working instructions
Torque
Smaller screws/bits can be damaged if you set the torque
o
or rotational speed too high.
Hard screw joints (in metal)
Particularly high torque occurs, for example in metal screw
o
joints made using drive sockets. Select a low rotational
speed.
Soft screw joints (e.g. in soft wood)
Again, use a low rotational speed, e.g. to avoid damaging
o
the surface of the wood upon contact with the screw head.
[ 3 ]
Use a countersink.
Drilling in wood, metal and other materials
Use a high speed for drill bits with small diameter and a
o
low speed for drill bits with large diameter.
Select a low speed for hard materials and a high speed for
o
soft materials.
Secure or fasten the workpiece in a clamp or vice (if
o
possible).
Mark the spot where you want to drill using a centre punch
o
or nail. Select a low rotational speed when starting.
cannot be locked.
.
[ 6 ]
, you can progressively
6 ] [
Speed
Lower speed
Higher speed
to illuminate
[ ]
lights up automatically as soon as
[ ]
stays on for an additional
[ ]
.
6 ] [