Connecting The Hob To The Mains Power Supply - Pkm In5-Fzf Bedienungsanleitung

The rear wall, adjacent and surrounding surfaces must therefore be able to
withstand an temperature of 90℃.
1. The induction hotplate must be installed by qualified personnel or
technicians. We have professionals at your service. Please never
conduct the operation by yourself.
2. The hob will not be installed directly above a dishwasher, fridge, freezer
washing machine or clothes dryer, as the humidity may damage the hob
electronics.
3. The induction hotplate shall be installed such that better heat radiation can be
ensured to enhance its reliability.
4. The wall and induced heating zone above the table surface shall withstand
heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to
heat.
6. A steam cleaner is not to be used.

Connecting the hob to the mains power supply

This hob must be connected to the mains power supply only by a suitably
qualified person
Before connecting the hob to the mains power supply, check that:
4. The domestic wiring system is suitable for the power draw by the hob.
5. The voltage corresponds to the value given in the rating plate.
6. The power supply cable sections can withstand the load specified on the
rating plate. To connect the hob to the mains power supply, do not use adapters,
reducers, or branching devices, as they can cause overheating and fire. The
power supply cable must not touch any hot parts and must be positioned so that
its temperature will not exceed 75℃ at any point.
Check with an electrician whether the domestic wiring system is
suitable without alterations.
Any alterations must only be made by a qualified electrician.
47