Installation Instructions; Selection Of Installation Equipment - Pkm In5-Fzf Bedienungsanleitung

Installation Instructions

Selection of installation equipment

Theappliance must be installed and connected in accordance with current
regulations.
After unpacking the appliance, ensure there is no visible damage. If it has been
damaged during transit, DONOTUSE, contact where you buy immediately.
Selection of installation equipment
-Cut out the work surface according to the sizes shown in the drawing.
-For the purpose of installation and use, a minimum of 5 cm space shall be
preserved around the hole.
-Be sure the thickness of the work surface is at least 30mm. Please select
heat-resistant work surface material to avoid larger deformation caused by the
heat radiation from the hotplate. As shown below (measure by unit: mm):
L W H D A B X
(mm) (mm) (mm) (mm) (mm) (mm) (mm)
770 520 60 56 750+5 490+5 50
mini
-0 -0
Under any circumstances, make sure the electric hob is well ventilated and the
air inlet and outlet are not blocked. Ensure the electric hob is in good work state.
As shown below:
45