ROëDrawbar eyes
2.1. Weld-in drawbar eyes
Observe the installation position [1]
depending on the drawbar eye
Align the drawbar eye [2] at an angle to
the drawbar
Observe the minimum weld quality
requirement according to ISO 5817-B
Observe the permissible welding
procedure; table 1.4
Observe the filler metal ‚minimum
requirement'; table 1.4
Carry out welding in accordance with the
following table: „Welding instructions"
10.2017
[1] Installation position (phase at top)
°
9 0
[2] Angled installation
ROCKINGER
Member of JOST-World
2. Installation
31
EN