Welding Process - Rockinger Roe 57065 Montage- Und Betriebsanleitung

ROëDrawbar eyes

1.2 Welding process

General
Only welders with approved suitability
(EN 287-1 / EN ISO 9606 -I) are permitted to
perform welding work. The earth connection
must be established so that a problem-free
electrical contact is obtained. If the compo-
nents are moved during the welding work,
ensure that the weld seams and the tack
welds must only be stressed slightly and
must not tear.
cAution!
when performing welding work on vehic-
les, always exercise extreme caution to
ensure that the electrical cabling is not
damaged. connect the welding device's
negative cable as close to the vehicle's
welding point as possible.
Tack welding
If tack welds are part of the welded struc-
ture, the same criteria apply to these as to
the entire welded structure.
10.2017
1. General welding information
Tack welds are only permitted to be welded
over if they do not have any cracks and if
they fuse completely when being welded
over. Otherwise, the tack welds must be
removed once welding is complete.
ROCKINGER
Member of JOST-World
EN
27