IFM Electronic ecomat200 Counter Compact CP-1 DZ2001 Bedienungsanleitung Seite 21

Programming
Press the
1
Press the
Briefly press the
→ The indicator PRG is displayed, the parameter abbreviation flashes.
2
Press the
→ The indicator PRG goes out, the display is permanently lit
Press the
3
* You can set the multi-digit values (preset and time values) decade by
decade: Press the
active and counts until "0" is reached. Then the next decade starts. Set the
active decade by pressing the button once. Then the preceding decade flashes
and can be set.
If no button is pressed for 15s, the unit returns to the Run mode with
unchanged values.
Select the parameter to be changed
button until the desired parameter range is displayed.
(
or button until the desired parameter is displayed.
CH1 RUN
Set the parameter value
button to pass into the Programming mode.
or button until the desired parameter value
is displayed.*
Press the
(= acknowledgement of the new value).
Setting of additional parameters
or button until the requested parameter is indicated.
Proceed with step 2.
Exiting the Programming mode
Press the
(= the unit passes into the RUN mode).
or button and hold it. The smallest decade becomes
or ).
abbreviation of the parameter
current counter value
button for about 3s.
button for about 3s