IFM Electronic ecomat200 Counter Compact CP-1 DZ2001 Bedienungsanleitung Seite 22

Sensor adjustment
The sensor has an optimum pre-adjustment for most applications.
Check whether the target objects are safely detected. If this is not the
case, you can adjust the sensor for your application.
1. Adjustment for dynamic objects
1
Let the objects pass through the detection area of the sensor.
2
→ The indicator PRG is displayed, the indication
As soon as
→ The indicator PRG goes out, the indication
3
2. Adjustment for static objects
1
Remove the object from the detection area of the sensor.
2
→ The indicator PRG is displayed, the indication
As soon as
3
As soon as
→ The indicator PRG goes out, the indication
4
Briefly press the
to reach the parameter range 3 (
Press the or
Briefly press the
is displayed, press the
Press the
→ The unit passes into the RUN mode.
Briefly press the
to reach the parameter range 3 (
Press the or
Briefly press the
is displayed, place the object in the
detection area of the sensor.
Briefly press the
is displayed press the
Press the
→ The unit passes into the RUN mode.
button 3 times
button until
button once.
button for about 3s.
button 3 times
button until
button once.
or button once.
button for about 3s.
).
is displayed.
flashes.
button for about 3s.
is permanently lit.
).
is displayed.
flashes.
button for about 3s.
is permanently lit.