Troubleshooting - Parkside PWM B2 Bedienungs- Und Sicherheitshinweise

Press and hold UNIT button to clear all recorded readings are erased,
and then press MAX/MIN button. All recorded readings are erased.
The display shows 2/3MAX
3 ] [
maximum wind speed and the maximum temperature, which have been
recorded since you entered this mode.
Press and hold UNIT button to clear all recorded readings are erased,
and then press MAX/MIN button. All recorded readings are erased.
shows MIN
The display
[ 3 ]
and the minimum temperature, which have been recorded since you
entered this mode (Fig. E).
Press and hold UNIT button to clear all recorded readings are erased,
and then press MAX/MIN button. All recorded readings are erased.
shows AVG
The display
3 ] [
and the average temperature, which have been recorded since you
entered this mode.
44 GB/IE
together with two-thirds of the
14 ] [
together with the minimum wind speed
14 ] [
together with the average wind speed
14 ] [
Press and hold UNIT button to clear all recorded readings are erased,
and then press MAX/MIN button. All recorded readings are erased.
The product returns to measurement mode.
˜ Troubleshooting
Error
The measurement is obviously too
high or low.
The value in the display is not
3 ] [
reacting.
The value in the display is barely
[ 3 ]
visible.
Electrostatic discharges can lead to malfunctions. In the event of such
malfunctions, remove the batteries briefly and reinsert them.
Possible causes/solutions
Is shown in the display
[ 9 ] 3 ] [
If yes: Replace with new batteries.
H
Is shown in the display
11 ] [ 3 ] [
If yes: Briefly press HOLD .
6 ] [
The batteries are low (see "Inserting/
changing the batteries").