Inhaltsverzeichnis - PolyScience 13R Bedienungsanleitung

Table of Contents
Section 1 - General Information
1.1
1.2
Section 2 - Circulating Bath
2.1
2.2
2.3
2.4
2.5
2.6
2.7
Section 3 - Immersion Circulator
3.1
3.2
3.3
3.4
3.5
3.6
Section 4 - Standard Controller Information
4.1
4.2
4.3
Section 5 - Operation
5.1
5.2
5.3
5.4
5.5
5.6
5.7
5.8
5.9
5.10
5.11
5.12
Section 6 - Calibration and Maintenance
6.1.
6.2
6.3
6.4
6.5
6.6
Section 7 - Troubleshooting
7.1
7.2
7.3
7.4
7.5
7.6
7.7
Section 8 - Reservoir Fluids
Section 9 - Service and Technical Support
Section 10 - Replacement Parts
Warranty
Unpacking
Contents
General Description
Circulator Pump
Pump Inlet and Outlet Connections
Closed Loop Circulation
Filling the Reservoir
Reservoir Purge
Contents
General Description
Circulator Pump
Set-Up
Connections to External Apparatus
Attainable Temperatures
Front and Rear Panels
Heater/Pump Assembly
Specifications
Circulator Location
Reservoir Liquid Level
Power
Setting the Safety Set Set Point
Selecting Temperature Units
Setting the Software High Limit
Setting the Set point Temperature
User-Defined Preset Temperatures
LLO - Local Lockout Feature
Stick-on Strips for Preset Buttons
Auto-Refrigeration Operation
Controller Display Messages
Calibration
Heater
Pump Motor
Cleaning
Maintaining Clear Bath Water
Condenser, Air Vents, and Reusable Filter (Refrigerating/Heating Circulators only)
Unit Will Not Operate (No Heat, Cooling, or Pumping)
No Pumping
Slow or Insufficient Pumping
No Heating
Insufficient Heating
No Cooling or Insufficient Cooling
Triac Failure