Scheduled Maintenance Table - Nilfisk Floortec R 870 Kurzanleitung

ENGLISH
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defined by the person in charge of the maintenance.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.
WARNING!
To perform maintenance procedures, the machine must be off, the ignition key removed, and, if necessary, the
batteries must be disconnected.
Read carefully the instructions in the Safety chapter before performing any maintenance procedure.

SCHEDULED MAINTENANCE TABLE

Procedure
Battery charging
Battery (WET) fluid level check
Side and main broom height check
Brake cable check and adjustment
Hopper dust filter check and cleaning ("A" method)
Hopper hydraulic lifting system oil level check
Skirt height and operation check
Dust guard system water filter check and cleaning (optional)
Hopper dust filter check and cleaning ("B" method)
Filter shaker operation check
Main broom driving belt check
Steering chain cleaning
Safety system operation check
Brake pad check/adjustment/replacement
Hopper dust filter check and cleaning ("C" method)
(only for polyester dust filter)
Main broom driving belt check and/or replacement
Hopper gasket integrity check
Lifted hopper sensor operation check/adjustment
Motor carbon brush check and/or replacement
Hydraulic system oil change
(*) For the relevant procedure, refer to the Service Manual.
(1) Daily or after using the machine.
(2) Or before start-up.
(3) Or more frequently if the machine is used on slopes.
(4) Or more often in dusty areas.
(5) Change the hydraulic system oil after 500 hours or every year.
36
1464822000(1)03-2013.indb 36
QUICK START GUIDE
FLOORTEC R 870 - 1464822000
Every Every
Upon delivery 10
hours hours
(1)
(2)
(3)
(4)
(2)
Every Every
Every
50 100 200
hours hours
(4)
(*)
(*)
(*)
(2)
(*)(3)
(4)
(*)
(*)
(*)
year
(*)
(*)(5)
18-Mar-13 11:26:53