Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.
Store the pressure sprayer in a dry, dust-free
place.
15. Maintenance
The product has no internal parts that require mainte-
nance.
16. Repair & ordering spare parts
After repairs or maintenance, make sure that all safe-
ty-related parts are installed and are in perfect con-
dition. All parts which may cause injury must be kept
where they are inaccessible to children or others.
Attention: According to the German Product Liability
Act, no liability is accepted for damage caused by im-
proper repairs or by not using original spare parts.
Such work should be performed by a customer service
centre or an authorised specialist. The same applies to
accessory parts.
18. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your product failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
No pressure builds up in
the container.
Pressure sprayer does
not spray.
Possible cause
The pump is not screwed tight.
Safety valve leaking or defective.
The sealing ring of the pump is not
lubricated.
No pressure present.
Too little pressure present.
The nozzle is clogged.
No spray agent in the container.
Dirt filter is clogged.
www.scheppach.com
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
16.1 Ordering spare parts
Please provide the following information when order-
ing spare parts:
• Model designation
• Item number
• Type plate data
17. Disposal and recycling
Notes for packaging
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
Remedy
Screw the pump in tightly.
Replace the safety valve.
Grease the sealing ring of the pump.
Build up pressure with the pump.
Build up sufficient pressure with the pump.
Clean the nozzle.
Fill with spray agent.
Clean the dirt filter of the nozzle or the suction
hose.
GB | 25
Werbung
