Herunterladen Diese Seite drucken

Massoth DiMAX Navigator 2.4GHz Bedienungsanleitung Seite 14

Vorschau ausblenden Andere Handbücher für DiMAX Navigator 2.4GHz:

Werbung

• Möchten Sie aus dem Lokwahlmenü wieder
zurückkehren, ohne eine neue Lok zu wählen,
können Sie durch Drücken der Taste M3 in
den Fahrmodus zurückspringen, wenn Sie
noch keine neue Adresse eingegeben oder Lok
ausgewählt haben.
4.3.1. Belegte Lok
Wenn Sie eine belegte Lok auswählen, wird dies
im Display mit einem Loksymbol mit durchge-
kreuztem Loksymbol angezeigt. Das bedeutet
die angezeigte Lok ist in der Zentrale als belegt
gekennzeichnet. Diese muss erst ordnungsge-
mäß abgemeldet werden.
Zusätzlich gibt es noch Sondermeldungen
im Display, die folgende Bedeutung haben:
• „T"= Timeout: Zentrale antwortet auf Lokanmel-
dung nicht
• „L"= Lokspeicher voll: Anzahl aktivierter Loks in
Zentrale erhöhen
4.3.2. Abmelden einer Lok
Eine auf dem DiMAX Navigator angemeldete
Lokomotive ist reserviert und kann durch andere
Teilnehmer nicht übernommen werden, wenn
diese von Ihnen nicht explizit freigegeben wird.
Dies geschieht ganz einfach durch das Öffnen
des Lokwahlmenüs (Kurz Taste M2). Dabei wird
die gesteuerte Lok automatisch abgemeldet.
14
• You may return to the operation mode without
selecting a new locomotive, if you have not
selected or entered a new loco address with M3.
4.3.1. Occupied Loco
If you select an occupied loco, this is in-
dicated in the display with a loco symbol
with a dwarted loco symbol. This means the
displayed loco is characterized in the as oc-
cupied. These must first be logged properly.
In addition there are special messages in
the display have the following meanings:
• „T"= Timeout: Central station does not reply to
loco registration
• „L"= Loco memory full: Increase number of
activated locos in the central station
4.3.2. Deselecting a locomotive
Operated locomotives are assigned to the
used Navigator and are not available for oth-
ers unless it is deselected. The actual loco
is automatically deselected when the loco
selection mode is started with M2. The
recently used locomotive immediately released
and may be selected by other players.

Werbung

loading

Diese Anleitung auch für:

8134801