Connection With The Mains; Operation; Control Board - EuroLite LED PFE-100 RGBW Profile Spot Bedienungsanleitung

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
The device is equipped with a lockable power input connector. Plug in the power cord and turn it to the right
until it locks. Plug the power cord into a grounded electrical outlet that matches the rated voltage of the
machine.

OPERATION

After you connected the spot to the mains, the EUROLITE LED PFE-100 RGBW Profile Spot starts running.
The LC display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP and
DOWN.
The device has two operating modes. It can be operated in stand-alone mode via the control board or in
DMX-controlled mode via any commercial DMX controller.

Control Board

The Control Board offers several features: you can easily set the starting address or run the desired program
in manual mode.
MODE ENTER DOWN UP
- STAND ALONE-MODE
Dimmer
•
Strobe
•
Fade
•
Auto
•
Master / Slave
•
Focus
•
Zoom
•
- DMX MODE
International
L
N
Enter the menu by pressing the MODE-button. Browse through the
menu by pressing UP or DOWN. Press ENTER in order to select the
desired menu. You can change the selection by pressing UP or
DOWN. Press ENTER in order to confirm. You can leave every mode
by pressing MODE. The functions provided are described in the
following sections.
LC Display
DMX512
Dimmer R
Dimmer G
Dimmer B
Dimmer W
Strobe
Fade
Auto
Setting of the DMX starting address from 001 - 512
Setting the dimmer brightness for the red LEDs
Setting the dimmer brightness for the green LEDs
Setting the dimmer brightness for the blue LEDs
Setting the dimmer brightness for the white LEDs
Setting of the strobe speed
Setting of the fade program speed
Setting of the auto program speed
21/31
Function
00094626.DOC, Version 1.1