Stand Alone-Mode - EuroLite LED PFE-100 RGBW Profile Spot Bedienungsanleitung

STAND ALONE-MODE

In the Stand Alone mode, the LED PFE-100 RGBW Profile Spot can be used without controller.
Disconnect the LED PFE-100 RGBW Profile Spot from the controller.
Dimmer
Press the MODE button until the display shows "Dimmer R". Press ENTER to confirm.
You can now select the desired brightness of the red LEDs via the UP or DOWN buttons.
Value:
000 – 4096
Press ENTER once again to confirm your choice. Press the MODE button in order to return to the main
menu.
You can now set the brightness setting of the green, blue and white LEDs in the same manner.
Strobe
Press the MODE button until the display shows "Strobe. Press ENTER to confirm
Via the UP or DOWN buttons, you can set the desired strobe speed. You can choose from 13 speeds, with
increasing rate.
Value:
00 ~ 12
Press ENTER once again to confirm. Press the MODE button in order to return to the main menu.
Fade
Press the MODE button until the display shows "Fade. Press ENTER to confirm
Via the UP or DOWN buttons, you can set the desired fade speed. You can choose from 13 speeds, with
increasing rate.
Value:
00 ~ 12
Press ENTER once again to confirm. Press the MODE button in order to return to the main menu.
Auto
Press the MODE button until the display shows "Auto. Press ENTER to confirm
Via the UP or DOWN buttons, you can set the desired auto program speed. You can choose from 13
speeds, with increasing rate.
Value:
00 ~ 12
Press ENTER once again to confirm. Press the MODE button in order to return to the main menu.
Master/Slave
Set the Master device to Dimmer, Strobe, Fade or Auto mode and set each Slave device to the same DMX
address "001".
Function:
0 – 100 % increasing brightness
Function:
Speed 0 ~ Speed 12
Function:
Speed 0 ~ Speed 12
Function:
Speed 0 ~ Speed 12
22/31 00094626.DOC, Version 1.1