Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Mounting Method
3-1. Mounting Precautions
3-1-1. Checking the mounting method
Check that the scale unit can be mounted in the relative
position shown in the figure.
Horizontal Installation
Note
When mounting the scale unit to a machine tool or other
device, mount the unit so that the slider reaches the side
opposite the cut object (work side).
22
Working surface
Vertical Installation
3-1-2. Setting the operating range
＊
Measuring length mark
＊ : Mount the scale so that the slider center moves within this rang.
1. The effective movement length marks D on both ends
of the top of the scale indicate the effective length.
2. Check the service length (maximum movement length)
of the device (X-Y stage, etc.) to which the scale unit is
to be mounted.
Note
Care should be taken as the service length (maximum
movement length) of the X-Y stage or other device may
be greater than the operating range indicated in the
catalog.
3. Set the scale unit position so that the slider center is
inside the effective movement marks.
SR118
Slider center
Werbung
