Herunterladen Diese Seite drucken

TEUFELBERGER OP LOOP Herstellerinformation Und Gebrauchsanleitung Seite 6

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 8
waRninG / tRanspoRt, stoRaGe & cLeaninG / ReGULaR checks
PRIOR TO USE
Prior to every use, this product must be subject to
a visual inspection in order to verify its integrity,
readiness for use and proper functioning. Once
the product has been subject to a fall, its use must
be discontinued immediately. If the slightest doubt
remains, the product must be retired or may not be
used again until a duly compentent person, having
subjected such product to the required testing and
inspections, has approved its further use in writing.
It must be ensured that the recommendations for
use with other components be complied with: ropes
need to meet EN 1891, while carabiners need to
meet EN 362. Further PPE components must meet
the harmonized standards under the regime of
regulation (EU) 2016/425. Ensure all neighbouring
components are compatible. Ensure all components
are correctly configured. Failure to do so increases
risk of serious injury or fatality.
It is the responsibility of the user that a relevant
and 'live' Risk Assessment is in place for the work
to be carried out which includes emergency con-
tingencies. A plan of rescue measures that covers
all foreseeable emergencies needs to be in place
before this product can be used. Prior to and during
use, rescue measures that can be executed safely
and effectively must be considered at all times.
5. WARNING AND SECURITY
– If there exists only the slightest doubt about the safe
condition of the product, be sure to replace such
product immediately.
– A system that has been exposed to a fall shall be
retired, or be returned to the manufacturer or a duly
qualified repair shop for maintenance and testing.
– Snow, ice, and moisture may affect the product's
handling and strength.
– Be sure to avoid high temperatures, sharp edges,
and exposure to chemicals (e.g., acids). Rappel
slowly to prevent the generation of great heat. UV
radiation and abrasion have an adverse impact on
the rope and its strength.
– Knots in the rope may cause a significant reduction
of its breaking load.
6. TRANSPORT,
6
STORAGE AND CLEANING
The product consists of aramide and PES. Aramides
are not UV-resistant. Sunlight and chemicals may
attack the material so it will lose in strength. If
reactions such as discolouration, hardening and
similar show on the product, it shall be discarded
for reasons of safety.
When transporting the product, it must always be
protected form light and dirt and provided with
suitable packaging (moisture-repellent material
that is impervious to light).
Conditions of storage:
– Protected from light (UV radiation, welding
machines ...)
– Dry and clean
– At room temperature (15 - 25 °C)
– Not in the proximity of chemicals (acids, lyes, liquids,
vapours, gases, ...) and other aggressive environments
– Protected against sharp-edged objects
Therefore, store the product dry and ventilated in
a moisture-repellent bag that is impervious to light.
For cleaning, use lukewarm water and – if available – a
rope detergent in accordance with the cleaning instruc-
tions provided thereon. Do not use a textile detergent.
Following cleaning, rinse the product with plenty of
clear water. In any event, prior to storage or use, allow
the product to dry completely in a natural way and not
in direct sunlight, or near fires or other heat sources.
For disinfection, use only such substances that do not
have an impact on the synthetic materials used. Do not
disinfect the product more often than is absolutely nec-
essary! We recommend the use of isopropyl alcohol 70%.
Apply the disinfectant to the surface for about 3 minutes
and allow the product to dry naturally. Be sure to observe
the safety instructions for the use of the disinfectant.
If you fail to observe these provisions, you will be putting
yourself into danger!
7. REGULAR CHECKS
Checking the equipment at regular intervals is ab-
solutely necessary: your safety depends on the
effectiveness and durability of the equipment!
Following each use, the product should be checked
for abrasion and cuts. Also check it for the legibility

Werbung

loading