Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SECURING YOUR BABY
SECURING YOUR BABY USING THE
BABY INSERT
use the baby insert attached to this car
Please use the baby insert attached to this car
seat when your babys height is less
hen your baby 's height is less than 87cm.
than 87cm.
The baby insert is used to provide extra com-
fort for very small babies, and it gives
aby insert is used to provide extra comfort
your baby the necessary support while he or
she is still small.
y small babies, and it gives your baby the
sary support while he or she is still small.
Baby lnsert
Always secure your baby in the car seat using the harness.
•
Never leave your baby unattended in the car seat when placing it on elevated surfa-
•
ces (e.g.a table, nappy changing unit, etc. )
Never allow the strap end to become caught in moving parts (e.g.automatic doors,
•
（
escalators, etc.).
Caution: The plastic parts of the car seat heat up in the sun, so that your baby may
•
get burnt. Protect your baby and the car seat against intensive solar radiation (e.g. by
putting a light cloth over the seat).
Take your baby out of the car seat as often as possible to relieve its spine. We
•
recommend frequent breaks during long journeys. Even outside of the car, please
！
avoid leaving your baby in the car seat for too long.
（
34
！
！
）
（
3.3 Securing your baby using the harness
，
！
！
，
，
HOW TO ADJUST THE BELTS HEADREST
AND SEAT POSITIONS
The correct belt height of the shoulder belts is attained when the belt disappears into the
shell slightly above the shoulder of the child.
Make sure that the shoulder belts fit properly over the shoulders of the child.
！
！
3.2-2 Eight heights of the headrest
2.
Eight heights of the headrest: The headrest
can be set at five different heights in group I
mode. There are three additional positions in Group
ll&ll mode once the shoulder pads and harness straps
has been removed.
Press and pull the handle behind headrest. lt is import-
ant to make sure the headrest fit properly to head.
！
！
FREEFIX I-SIZE
，
1.
Adjusting the belts: Loosen the harness straps by
pressing the release button and pulling the harness
straps as far as you can. Note: Do not pull the shoulder
pads.
3.
Securing your baby using the harness: Loosen the
harness straps by pressing the release button and
pulling the harness straps as far as you can.
pull the shoulder pads.
DE
EN
FR
NL
Note: Do not
35
Werbung
