Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Chapter 2. Machine installation
2.1. Transport and positioning
It is recommended to handle with great care during transport and positioning!
Use protection gloves while handling the machine.
Cut the strap with scissors make sure you protect your eyes by wearing glasses and withdraw the cardboard (figure
2.1.A page 58).
Remove the waste film rewinder.
Remove the cardboard containing the trolley.
Take away the reel support (5).
Unscrew the 4 fastening screws (A) of the pallet, putting the 4 plates back inside the machine (B).
Assemble the trolley (figure 2.1.B page 58).
Lift the machine and place it on its trolley, paying attention that the 4 supports are properly inserted in their housings.
Remove the upper hood by cutting the strings.
If it is transported by hand, 4 people are required for its transportation.
When lifting the machine, always grip it by the ends and never by the reel support (5).
To place the reel support (5) follow the instructions below (figure 2.1.C page 58):
Remove the adhesive tape (A) fixing the guides trolley.
Place the reel support (5) on the proper guides.
Stride over the blocking device (B) through a working tool (for example a screw driver).
Position the waste film rewinder according to the attached instructions.
2.2. Environmental conditions
Place the machine in a suitable environment free from humidity, gases, explosives, combustible materials.
Leave a minimal space of 200mm around the machine so that not to obstruct air outlets (figure 2.2. page 58).
Once the correct height is abtained, block the machine by means of the wheel brakes.
Working environmental conditions:
Temperature from + 5°C to + 40°C
Relative humidity from 30% to 90%, without condensation
The lighting of the operation room shall comply with the laws in force in the country where the machine is installed.
However, it shall be uniform and provide for good visibility in order to safeguard the operator's safety and health.
MACHINE SAFETY FACTOR = IP20
THE AERIAL NOISE MADE BY THE MACHINE IS LOWER THAN 70 dB
2.3. Electrical connections
OBSERVE HEALTH AND SAFETY REGULATIONS!
If the machine is not equipped with the power supply plug, use a plug that is suitable for the voltage and
amperage values described by the rating plate and that can comply with the rules in force in the installation
country.
GROUNDING OF THE UNIT IS OBLIGATORY! (figure 2.3. page 58).
Before executing electrical connections, make sure the mains voltage matches the one on the plate on machine rear and
that the ground contact complies with the safety rules in force.
In case of doubts about the mains voltage, contact the local public supply Company.
11
GB
Werbung
