Changing The Door Hinge; Installing The Refrigerator - Waeco CoolMatic HDC275 Montage- Und Bedienungsanleitung

HDC275
7.1

Changing the door hinge

You can also change the hinge of the doors, so that the doors open to the left
rather than the right.
➤ Unscrew and remove the top bolts (fig. 2 1, page 3).
➤ Remove the upper door (fig. 2 2page 3).
➤ Remove the spacer (fig. 2 3, page 3).
➤ Remove the middle hinge (fig. 3 1, page 3).
➤ Remove the lower door (fig. 3 2page 3).
➤ Unscrew and remove the bottom bolts (fig. 4 1, page 4).
On the opposite side:
➤ Fasten the bottom bolts.
➤ Attach the lower door.
➤ Fasten the middle hinge firmly.
➤ Fit the spacer.
➤ Attach the upper door.
➤ Fasten the top bolts.
7.2

Installing the refrigerator

Observe the following instructions when installing:
 Install the refrigerator so that the warm air produced can easily flow away
(either upwards or to the sides, fig. 5, page 4).
Key for fig. 5, page 4
No. Explanation
1 Cold intake air
2 Hot waste air
3 Spacing above the refrigerator if there is not sufficient air to
circulate above or at the side.
 Leave the device to stand for at least four hours before you connect it to
the power supply so that the oil can flow back into the compressor.
EN
Installing and connecting the refrigerator
39