Changing The Door Hinge; Installing The Refrigerator - Waeco CoolMatic HDC155FF Montage- Und Bedienungsanleitung

Installing and connecting the refrigerator
7.1

Changing the door hinge

You can also change the hinge of the door, so that it opens to the left rather
than the right.
➤ Proceed as shown in the illustrations (fig. 2, page 3 to fig. 5, page 5).
7.2

Installing the refrigerator

Observe the following instructions when installing:
 Install the refrigerator so that the warm air produced can easily flow away
(either upwards or to the sides, fig. 6, page 5).
Key for fig. 6, page 5
No. Explanation
1 Cold intake air
2 Hot waste air
3 Spacing above the refrigerator if there is not sufficient air to
circulate above or at the side.
 Leave the device to stand for at least four hours before you connect it to
the power supply so that the oil can flow back into the compressor.
 The installation dimensions can be found in fig. 7, page 6.
Proceed as follows to install the refrigerator:
➤ Proceed as shown in the illustrations (fig. 7, page 6 to fig. 8, page 7).
➤ Fix the cover panel to the refrigerator door as shown in the illustrations
(fig. 9, page 7 to fig. c, page 9).
7.3 Connecting the refrigerator to the power supply
A
NOTICE!
 To avoid voltage drops and loss of performance, keep the
connection cable as short as possible and not be interrupted.
Therefore avoid additional switches, plugs or power strips.
 Disconnect the cooling device and other electric consumers
from the battery before you connect the battery to a quick
charging device.
Overvoltage can damage the electronics of the device.
40
HDC155FF
EN