Waeco CoolMatic HDC275 Montage- Und Bedienungsanleitung Seite 40

Installing and connecting the refrigerator
Proceed as follows to install the refrigerator:
➤ Shorten the sealing strip if required and fit it on the refrigerator (fig. 6,
page 5).
➤ Install the refrigerator as shown in the illustrations (fig. 7, page 5 to
fig. f, page 6).
Please note the following:
– fig. 8, page 5: You can make sure that the space between the refrig-
erator and the installation opening is right by using the bottom hinge
cover.
– fig. a, page 6: Remove the DX part for right-hand hinges and the
SX part for left-hand hinges.
➤ Fix the cover panel to the refrigerator door as shown in the illustrations
(fig. g, page 7 to fig. l, page 7).
7.3 Connecting the refrigerator to the power supply
A
NOTICE!
 To avoid voltage drops and loss of performance, keep the
connection cable as short as possible and not be interrupted.
Therefore avoid additional switches, plugs or power strips.
 Disconnect the cooling device and other electric consumers
from the battery before you connect the battery to a quick
charging device.
Overvoltage can damage the electronics of the device.
The refrigerator can be operated with a 12 Volt or 24 Volt DC voltage supply.
For safety reasons, the refrigerator is equipped with an electronic system to
prevent the polarity being reversed. This protects the refrigerator against
reversed polarity when connecting to a battery and against short circuiting.
To protect the battery, the refrigerator switches off automatically if the voltage
is insufficient (see table below).
Cut-off voltage
Cut-in voltage
40
12 V
10.4 V
11.7 V
HDC275
24 V
22.8 V
24.2 V
EN