Changing The Door Hinge - Waeco COOLMATIC R Serie Bedienungsanleitung

_r-kuehlschraenke.book Seite 31 Donnerstag, 14. Oktober 2010 4:34 16
COOLMATIC R series
6.3

Changing the door hinge

You can also change the hinge of the door, so that it opens to the left rather
than the right.
Note:
To change the decor plate of the RPD-190 model, please contact
your specialist dealer.
To change the door hinge, proceed as follows (6, page 5):
➤ Remove the upper door hinge (6 1, Page 5).
➤ Carefully lift out the door.
➤ Remove the threaded pins (6 2, Page 5).
➤ Pull the locking hook (6 3, Page 5) off the rod.
➤ Remove the locking plate (6 4, Page 5) and fit it on the opposite side.
➤ Pull the rod downwards and out and put it in the other side.
➤ Fasten the locking hook (6 3, Page 5) back on the rod.
➤ Detach the top and bottom lock holders (6 5, Page 5) on the left side.
➤ Detach the top and bottom door hinges (6 1, Page 5) on the right side.
➤ Fasten the top and bottom door hinges (6 1, Page 5) to the left side.
➤ Fasten the top and bottom lock holders (6 5, Page 5) to the left side.
6.4 Changing the decorative plate
You can change the decorative plate on your refrigerator to improve the ap-
pearance.
This is how to change the decorative plate:
➤ Remove the screws 1 and 3 (7 1 and 3, Page 5).
➤ Remove components 2 and 4 (7 2 and 4, Page 5).
➤ Pull down the old decorative plate out of the door frame.
Caution: there is a risk of injury!
➤ Put the new decorative plate in the door frame.
➤ Fit the components 2 and 4 (7 2 and 4, Page 5) back on the device.
➤ Fasten the screws 1 and 3 (7 1 and 3, Page 5).
Setting up and connecting the refrigerator
31