Changing The Door Hinge - Waeco COOLMATIC CR-Serie Bedienungsanleitung

_cr-kuehlschraenke.book Seite 41 Montag, 6. April 2009 1:03 13
COOLMATIC CR Series
If you put the refrigerator in a recess, you can fix it inside with suitable
screws:
7.2
The refrigerator has a locking mechanism (fig. 9 1, page 6) which is also
used, to protect it during transport. The following settings are possible:
a
7.3
You can also change the hinge of the door, so that it opens to the left rather
than the right.
Downloaded from www.Manualslib.com
Choose the condensation outlet most suitable for the place of installation
and remove its cap.
Insert a sharp object (e.g. a screwdriver) approx. 25 to 30 mm into the
outlet to pierce open the inside of the appliance.
Remove the blanking plugs (fig. 7 2, page 6).
Push the refrigerator into the recess.
Use suitable screws (fig. 7 1, page 6) to fix the refrigerator in place.
Press the blanking plugs (fig. 7 2, page 6) into the openings.
Undo the lock
Caution
Only adjust the locking mechanism when the door is open. If you
use it with the door closed, you will damage the device.
Lock (turn wheel clockwise to the end stop): The door is locked and
secured.
To open the door, lift the handle up and open it.
Vent (turn wheel anti-clockwise to the end stop): The door is slightly open,
but fixed in position.
Use this position, if you are not going to use the appliance for a long time.

Changing the door hinge

Proceed as shown in fig. b, page 8 to fig. d, page 8, to change the
hinges.
manuals search engine
Installing and connecting the refrigerator
41