Inhaltsverzeichnis
Werbung
4. Bedienelemente und Anschlüsse am Gerät
8
13
7
14
5
6
1
9
11
12
10
2
3
4
-12-
5.2. Using the stand
Use your meter's stand to prop up the meter. If you prop your
meter on a bench-top, the stand helps provide a better viewing
angle.
To use the stand as a prop, just open it away from the meter
and set it on a flat surface.
6. How to make measurements
Understanding Phantom readings:
In some DC and AC voltage ranges, when the test leads are
not connected to any circuit, the display might show a phantom
reading. This is normal. The meter's high input sensitivity
produces a wandering effect. When you connect the test leads
to a circuit, accurate reading appear.
6.1. Measuring AC/DC voltage
WARNING!
Do not try to measure a voltage greater than 1000 V DC or
750 V AC. You might damage your meter and expose yourself
to a severe shock hazard.
Follow these steps to measure DC/AC Voltage.
1. Set the rotary selector to the V
range as required for the voltage level to be measured. If
you do not know the voltage level, start with the range
switch set to the highest voltage position and reduce the
setting as needed to get a reading.
)
)
2. Press
)
to select between DC and AC.
°
position. Select the
-49-
Werbung
Inhaltsverzeichnis
