Pkm IN4B-3G Bedienungsanleitung Seite 54

 The top closing edge of the cabinet (1) must not be flush with the installation opening
(2). Install the closing edge in offset positioning (1) or bevel the closing edge (3).
1. Before installing the hob to the worktop, the adhesive seal has to be fixed on the
bottom edge of the hob properly.
The seal has to be fixed properly. The outer side of the seal must match the bottom
outer edge of the hob (s. fig. below). The seal must be fitted tightly on the bottom
edge of the hob (no overlaps, no gaps etc.) to prevent liquids etc. from entering the
installation opening subsequently.
1
2
3
4
5
6
2. Insert the hob into the installation opening and push it downward carefully until the
hob is in firm contact to the worktop.
3. Fix the hob at the bottom of the worktop using the fixing brackets (s. below).
I
NSTALLATION OF THE HOB
Seal
Hob
Worktop
Outer edge of the hob
Outer side of the seal
Bottom of the hob
53
: