Flashforge Guider 3 Benutzerhandbuch Seite 19

The printed model is warping or not sticking well. How to deal with this situation?
Method 1: Increasing the platform temperature can effectively alleviate this problem, as
the high temperature can increase the adhesion between the platform and the model.
Method 2: Choose to add a raft when slicing the model can effectively alleviate this
problem.
Method 3: Apply glue.
Method 4: If the distance between the nozzle and platform is too large, it should be
recused accordingly, which can be done via the expert mode of extruder calibration and
the calibration function.
Method 5: Confirm whether the platform is laid flat. The calibration function can be
used, and it is recommended to perform a full-process automatic levelling.
Must a raft be added when printing a model?
Not necessarily. When printing the raft, the filament extrusion amount is larger, and the
printing success rate is higher. Under the condition of raft heating, the adhesion
between the model and the platform plate increases, which makes the model adhere to
the platform well when printing, and also increases the printing success rate.
What to do with the Wi-Fi connection failure?
Please check if the Wi-Fi name contains special characters. If so, modify it and try again.
Furthermore, please check if the password contains special characters. If so, modify it
and try again.
What to do during a firmware update?
Do not power off the printer or disconnect from the network during firmware download
or update to prevent update failures.
Why is the boot screen white?
If the startup sound can be heard, please replace the screen or cable. If not, please
contact the Alza customer care.
19