Flashforge Guider 3 Benutzerhandbuch Seite 13

Filament Screen
The filament screen includes: [Load], [Unload], and [Clean].
During filament loading and unloading, users can select on the screen the
corresponding filament to be installed. If the currently used filament is not listed on the
screen, users can customize the filament and set the required temperature for filament
loading.
Filament Cleaning
When the filaments printed in the last two times are different, please carry out filament
cleaning. In this way, it will avoid the situation that the carbonized filament leads to
nozzle clogging or there is no filament extrusion due to different melting temperatures
of different filaments. When switching from a filament of high printing temperature to a
filament of low printing temperature, this operation must be performed.
For example, when you need to switch to PLA filament after printing with PC filament, it
is necessary to clean and remove the PC filament from the nozzle. It is necessary to set
the temperature required for melting PC filament until all the PC filament is extruded
from the nozzle and there is no residue left in the nozzle.
13