Flashforge Guider 3 Benutzerhandbuch Seite 11

Camera Connection
Before using the camera, remove the camera cover. Turn on the camera switch, and
after the equipment is connected to FlashPrint, the real-time videos and images can be
viewed in the FlashPrint – [Multi-Machine Control].
Model Removal After Finishing Printing
Warning: When removing the model from the build plate, please let the platform cool
down first. You can check the temperature icon on the status bar of the screen to
confirm the platform temperature. Green icon indicates that the platform temperature
is lower than 50 °C, which is the appropriate state for safe operation. Gloves can be used
to remove the model more safely. In the meantime, be aware of machine's high
temperature.
If the flexible steel plate platform is used, after printing is completed, directly lift the
handle to remove the flexible steel plate and bend the platform plate to remove the
model. If the glass platform is used, after printing is completed, directly remove the
model with a scraper.
When using the flexible steel plate platform, remove the model and put the platform
plate back into the equipment. To do that, hold the rear end of the flexible steel plate
against the positioning blocks on the left and right edges of the platform. Note that it is
inserted into the inside of the positioning blocks. The platform will be automatically
adsorbed and installed into the platform.
11