Settings Screen - Flashforge Guider 3 Benutzerhandbuch

Settings Screen

Several functions can be turned on or off in the settings screen.
When [Air] is turned on, the fan on the back of the printer will be started. The
•
front of the fan is equipped with HEPA filter cotton, which can filter the dust and
odour generated during printing.
When [Platform Temp] is accessed, the platform insulation time before and after
•
printing can be set. When the printer is in the transition state of removing the
model, avoid increasing the time of reheating when the temperature drops.
When this function is turned on, the platform remains the heating state when
removing the model after finishing printing. Please pay attention to high
temperature and prevent burns and scalds.
When [Led] is accessed, the brightness of the light inside the chamber can be
•
adjusted.
When [Detect Filament] is turned on, the printer will stop printing when the
•
filament turns out during printing.
When [Recover Print] is turned on, if the device encounters a power failure
•
during printing, the device will automatically store the current printing position
data. Then it will proceed with printing the current model after the power is
restored.
When [Power Off] is turned on, the printer will automatically shut down after
•
finishing model printing.
15