Werbung
Verfügbare Sprachen
Verfügbare Sprachen
● Power Limitation
The Power Limitation function allows the product to be
used while limiting its maximum absorption, adjusting the
absorbed power in all active cooking zones, ensuring that
the total absorbed power of the hob does not exceed the
set maximum absorption level.
Note: the setting must be made with the hob switched off,
without pressing the
ON/OFF (1) button, when the hob
is connected to the mains, or reconnected to the mains,
within the next 2 minutes.
To set the Power Limitation:
• press
(which will flash, only for the first 2 minutes
after the product has been switched on)
• while continuing to hold down
time, all the Selection/Display areas (2) of the cooking
zones in a counter-clockwise direction starting from the
front left zone (FR); a short acoustic signal will be emitted
with each press and when all the Displays (2) have been
pressed, it will be possible to release the key:
at this point, the Display (2) of the rear left zone (RL) will
show, in alternating sequence, the symbols
indicating that the setting can be made.
• select the Display (RL-2) then slide along the Selection
bar (3), until the Display shows the symbols
The Display (FL-2) will show the current setting with the
values in the table:
Displayed value
Power (Kw)
7.4 Kw (default setting)
4.5 Kw
3.1 Kw
To change the Power Limitation setting:
• press the Display (FL-2) then slide along the Selection
bar (3), to
set the new setting. To save the selection made, press the
ON/OFF (1) button for 2 seconds; an extended audible
signal will be emitted to confirm the setting.
● Bridge Zones
Thanks to the Bridge function, the cooking zones can
operate in a combined way, creating a single zone with the
same power level. This function allows evenly distributed
cooking with large-sized pots and pans.
It is possible to use the front cooking zone in combination
with the corresponding rear one (to check which zones
feature this function, see the illustrated part of this manual).
To activate the Bridge Function:
• simultaneously select both cooking zones you wish
to use
• the Display (2) of the "rear" cooking zone will show the
symbol
• using the Selection bar (3), it will be possible to set the
operating Level (Power), which will be shown on the
Display (2) of the "front" zone
To disable the Bridge Function, simply repeat the activation
procedure
, press, one at a
Note: the Cooking Zone Timer, activated during the Bridge
Function, causes the automatic shut-down of both cooking
zones, as in this case they are considered a single
combined area.
● Key Lock
The Key Lock allows you to lock the settings of the hob to
prevent accidental tampering with the same, while leaving
the set functions enabled.
Activation:
• press
Note: if any other function is pressed while the Key Lock is
active, the symbol
is in use and must be deactivated if necessary in order to
use the hob.
and
,
● Automatic Heat UP
The Automatic Heat UP function allows the set power to be
and
;
reached more quickly; with this function it is possible to
cook food faster without the risk of burning it, insofar as the
temperature does not exceed the set level. This function is
available for power levels from
Activation:
• with the cooking zone on, press
will show a flashing
the cooking zone.
By increasing the power level of the cooking zone: the
Automatic Heat Up function remains active, with the new
temperature setting;
By decreasing the power level of the cooking zone: the
Automatic Heat Up function is deactivated.
Note: by selecting another cooking zone at the same time,
the symbol
light intensity, and it will be possible to proceed, also for
this zone, with the activation of the function; in any case,
20
(10) Repeat the operation to deactivate.
will flash to indicate that the function
to
, alternating with the power set in
(7) will go back to being illuminated with
.
(7), the Display (2)
Werbung
