Werbung
Verfügbare Sprachen
Verfügbare Sprachen
16. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Device does not start
Motor stops during
operation
Vibrations are too
strong
The height adjustment
does not work.
32 | GB
Possible cause
No power supply
Triggered overload pro-
tection
On/off switch defective
Engine defective
Triggered overload pro-
tection
Engine defective
Screws or parts of the elec-
tric tool are loose.
The cutter is not properly
inserted.
The workpiece is not prop-
erly fastened.
Height adjustment guides
dirty.
www.scheppach.com
Remedy
Check the power connection and the socket.
Allow the engine to cool down.
Repair by an authorised service centre.
Repair by an authorised service centre.
Allow the engine to cool down.
Repair by an authorised service centre.
Tighten up all the screws.
Insert the cutter correctly.
Fasten the workpiece.
Clean the height adjustment guides.
Werbung
