Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Vibration parameters
Vibration value per EN 62841
Vibration a
h
Uncertainty K
h
The specified vibration emission value has been meas-
ured according to a standardised testing procedure
and can be used for comparison of one power tool with
another; and may change depending on the way in
which the power tool is used and in exceptional cases
may be higher than the specified value.
m Warning:
In case of extended working periods, the operating per-
sonnel may suffer circulatory disturbances in their hands
(vibration white finger) due to vibrations.
Raynaud's syndrome is a vascular disease that causes
the small blood vessels on the fingers and toes to cramp
in spasms.
The affected areas are no longer supplied with sufficient
blood and therefore appear extremely pale. The fre-
quent use of vibrating devices can cause nerve damage
in people whose circulation is impaired (e.g. smokers,
diabetics).
If you notice unusual adverse effects, stop working im-
mediately and seek medical advice.
Observe the following information to reduce hazards:
• Keep your body and especially your hands warm in
cold weather.
• Take regular breaks and move your hands to promote
circulation.
• Ensure as little vibration as possible at the device via
regular maintenance and stable parts on the device.
8. Unpacking
• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the device by means of the
operating manual before using for the first time.
• With accessories as well as wearing parts and spare
parts use only original parts. Spare parts can be ob-
4.3 m/s²
tained from your specialist dealer.
1.5 m/s²
• When ordering please provide our article number as
well as type and year of manufacture for your equip-
ment.
m WARNING!
The device and the packaging material are not
children's toys! Do not let children play with plas-
tic bags, films or small parts! There is a danger of
choking or suffocating!
9.
Assembly
m ATTENTION!
Always make sure the device is fully assembled
before commissioning!
Before connecting the machine, make certain that the
data on the type plate matches with the mains power
data.
Warning! Always pull out the mains plug before
carrying out adjustments on the device.
Prior to commissioning, all covers and safety devices
must be mounted correctly.
Fitting the suction adapter (Fig. 4)
Caution! For health reasons, the use of a dust ex-
tractor is absolutely necessary.
• Screw the suction adapter (12) onto the top of the
base plate (3) using the screws provided.
• Connect the reduction piece (11) into the suction
adapter (12).
• Connect a suitable suction system to the suction
adapter (12) or to the reduction piece (11).
Fitting the copying sleeve (Fig. 5)
• Place the copying sleeve (15) on the base plate (3)
from below and secure it using the screws provided.
• Attention!
The barrel ring must point downwards.
Fitting the parallel stop (Fig. 6)
• Loosen the two wing screws (2) for the guide shafts
(20).
www.scheppach.com
GB | 27
Werbung
