Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.
Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new device brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling
• Non-compliance with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts
• Application other than specified
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE0113 not being observed
Note:
Read through the complete text in the operating manu-
al before installing and commissioning the device.
This operating manual should help you to familiarise
yourself with your device and to use it for its intended
purpose.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and extend-
ing the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture. They must be
read and carefully observed by all operating personnel
before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards.
The required minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description (Fig. 1 - 17)
1.
Speed control
2.
Wing screw
3.
Base plate
4.
Step stop
5.
Depth stop
6.
Spindle locking button
7.
Wing screw
8.
Fine adjustment
9.
Switch lock
10. On/off switch
11. Reduction piece
12. Suction adapter
13. Tightening lever
14. Parallel stop
15. Copying sleeve
16. Centring pin
17. Clamping sleeve
18. Open-ended spanner
19. Allen key
20. Guide shaft
21. Union nut
22. Rotary knob
23. Scaling ring
24. Wing screw for fixing
25. Screws
26. Sliding blocks
3. Scope of delivery (Fig. 3)
• Router
• Cutter set 20 pieces (not shown)
• Parallel stop (14)
• Copying sleeve (15)
• Suction adapter (12)
• Reduction piece (11)
• Centring pin (16)
• Clamping sleeve 6 mm (17)
• Clamping sleeve 8 mm (pre-fitted)
• Open-end spanner with elongated hole (18)
• Allen key, 2.5 mm (19)
• Operating manual
www.scheppach.com
GB | 23
Werbung
