Lionelo Brave Bedienungsanleitung Seite 16

Verfügbare Sprachen

hear a characteristic click. The seat belts are now fastened.

To tighten the belts, pull the belt tension adjustment strap (fig. 17). To loosen the

belts, press the belt tension adjustment button and pull on the shoulder belts (fig. 10).

Note! Make sure the seat belts are tight, fit tightly around the child's body and are not

twisted. Make sure the lap belts run low and protect the child's pelvis. The belts should be

tight against the child's body, but should not be too tight and cause discomfort.

NOTE! Children under 75 cm in height can use the seat only with a reduction pad.

RETRACTING 5-POINT SEAT BELTS

NOTE! The following information applies to the 100 – 150 cm group.

Unfasten the seat belts by pressing the red button on the buckle (fig. 15).

Remove the reduction pad (8, fig. A)

Adjust the headrest to the lowest available height (see: Headrest adjustment).

Unfasten the clasps located in the seat belt covers, and remove the belt sections from

the cover by removing them from the metal buckles (fig. 18).

Unfasten the metal clasps located on the lower part of the backrest cover.

Remove the seat belt buckle cover (10, fig. A), then put it through the corresponding

hole located in the seat cover.

Connect the belt connectors, and then insert them into the buckle. You will hear a

characteristic click.

Place the fastened seat belt buckle in the storage compartment located in the seat

under the seat cover. Close the storage compartment (fig. 19).

REMOVAL OF THE SEAT – ISOFIX

Press the ISOFIX sliding lever (14, Figure A) on both sides and release the ISOFIX arms. The

clasps will be released and the color of the ISOFIX indicators will change from green to red.

Retract the ISOFIX arms into the seat base by pressing the sliding lever.

REMOVAL OF THE SEAT – TOP TETHER

Loosen the belt. Unfasten the Top Tether belt from the anchor points in the car. The indicator

will turn red.

REMOVING AND ATTACHING THE COVER

Unzip the cover and slide it completely off the seat body. To do this:

Adjust the headrest to the highest available position (see: Headrest adjustment).

‑ 16 ‑