Lionelo Brave Bedienungsanleitung Seite 12

INSTALLATION IN THE CAR
Seat installation
- Installation with ISOFIX and Top Tether
belt
- Child fastened with seat belt
Adjust the seat to one of the 5 available
tilt positions of the backrest (see: Seat tilt
adjustment).
- Installation with ISOFIX and Top Tether
belt
- Child fastened with seat belt
Adjust the seat to one of the 5 available
tilt positions of the backrest (see: Seat tilt
adjustment).
- Installation with ISOFIX and car belts
– Installation with car belts alone
Put the seat in position number "1" –
sitting position (see: Seat tilt adjustment).
REARWARD-FACING (40 – 105 CM)
NOTE! Children under 75 cm in height can use the seat only with a reduction pad.
1. Place the seat on the car's bench seat in the installation position.
2. Push in the ISOFIX sliding lever and extend the ISOFIX arms (fig. 1). Make sure the
arms are fully extended.
3. Anchor the ISOFIX arms into the attachments located in the car's bench seat (fig. 2).
The arms will interlock and you will hear a characteristic click.
4. The green indicator on the ISOFIX button must be visible on both sides (fig. 3).
5. Press the seat against the backrest of the car's bench seat. Push the base with a left-
right movement towards the backrest to make sure it is pressed as tightly as possible
against the car bench seat (fig. 4).
6. Press the seat rotation button (11, fig. A), then move the seat to the rearward-facing
position (see: Seat rotation). Try to move the seat – properly anchored will not allow
EN
Seat Seat position
orientation
Rearward-
facing
Forward-
facing
Forward-
facing
‑ 12 ‑
Child's
measurement
From 40 to
105 cm
Child's weight:
maximum 18 kg
From 76 to
105 cm
Child's weight:
maximum 18 kg
From 100 to
150 cm