Lionelo Brave Bedienungsanleitung Seite 15

12. Fasten the seat belt. You will hear a characteristic click.
13. Make sure the belts are not twisted.
14. Make sure that the belts are correctly positioned in the guides and tightened, and
that the buckle is not too close to the lap belt guide (fig. 11).
SEAT ROTATION
The seat rotation mechanism is a feature that helps you comfortably position or remove
your child from the seat.
Press the seat rotation button (11, fig. A) and rotate the seat 90 degrees. With this function,
you can easily place and remove your child from the seat.
Press the seat rotation button (11, fig. A) again, and adjust the seat to the rearward or forward
facing position. Try to move the seat – properly anchored will not allow you to change position.
SEAT TILT ADJUSTMENT
To adjust the seat tilt, press the seat tilt adjustment lever (19, fig. A) and move the seat to
the desired position. The correct setting will be signaled by a click.
The seat has 5 levels of backrest tilt adjustment for forward and rearward facing (fig. 12).
HEADREST ADJUSTMENT
To change the headrest height:
1. Loosen the belts by holding down the seat belt tension adjustment button (fig. 10).
This will allow you to adjust the height of the headrest more freely.
2. Pull the headrest adjustment lever, then pull up or push the headrest down (fig. 13).
The shoulder belt height adjustment is integrated with the headrest height adjustment. By
adjusting the height of the headrest, the height of the shoulder belts will be set automatically.
Note! The headrest should be adjusted so that the shoulder belts are not too high, such
as at or above the ear line, nor too low, such as behind the child's back. The shoulder belts
should be at the child's shoulder height (fig. 14).
FASTENING AND UNFASTENING THE SEAT BELTS
1. Loosen the belts by pressing the seat belt tension adjustment button (fig. 10).
2. Unfasten the belts by pressing the red button on the buckle (fig. 15).
3. Place the child in the seat.
4. Adjust the headrest (see: Headrest adjustment).
5. Connect the belt connectors and then insert them into the buckle (fig. 16). You will
‑ 15 ‑ EN