Lionelo Brave Bedienungsanleitung Seite 14

you to change position.
7. Set the seat tilt to one of the 5 available positions (see: Seat tilt adjustment).
NOTE! Any change in the tilt of the backrest during use of the seat requires readjustment
of the length of the Top Tether belt.
8. Unbuckle the Top Tether belt (fig. 5), then press the length adjuster to adjust the length
of the belt and move the buckle and hook to the end of the belt (fig. 6).
9. Guide the Top Tether belt under the headrest of the car seat, and then attach it to
an anchor point in the car (fig. 7). The anchor points may be in different locations,
depending on the vehicle (fig. 8a).
10. Tighten the Top Tether belt as tightly as possible and make sure its indicator is green
(fig. 9). The seat is now properly installed in the car.
11. Loosen the seat's shoulder belts by pressing the belt adjustment button (fig. 10).
12. Fasten the seat belts (see: Fastening and unfastening the seat belts). Use the magnets
that hold the seat belts in place to make it easier when putting the child in the seat.
13. Place the child in the seat and adjust the headrest (see: Headrest adjustment).
14. Fasten the seat belts (see: Fastening and unfastening the seat belts).
REARWARD-FACING (100 – 150 CM)
1. Remove the reduction pad (8, fig. A)
2. Retract the seat belts (see: Retracting the 5-point seat belts).
3. Place the seat on the car's bench seat in the installation position.
4. Adjust the tilt of the seat in the sitting position (see: Seat tilt adjustment).
Note! If installing without ISOFIX, skip steps 5 through 8.
5. Push in the ISOFIX sliding lever and extend the ISOFIX arms (fig. 1). Make sure the
arms are fully extended.
6. Anchor the ISOFIX arms into the attachments located in the car's bench seat (fig. 2).
The arms will interlock and you will hear a characteristic click.
7. The green indicator on the ISOFIX button must be visible on both sides (fig. 3).
8. Press the seat against the backrest of the car's bench seat. Push the base with a left-
right movement towards the backrest to make sure it is pressed as tightly as possible
against the car bench seat (fig. 4).
9. Place the child in the seat and adjust the headrest (see: Headrest adjustment).
10. Pull out the car seat belt.
11. Pass the shoulder belt through the shoulder belt guide, which is located at the bottom
of the seat's headrest (6, fig. A). Pass the lap belt through the lap belt guide (15, fig. A).
EN ‑ 14 ‑