AEG MTE 350 Bedienungs Und Installationsanleitung Handbuch Seite 36

Installation - for contractors

» Route the power cable through the cable entry in the
back panel.
» Hook in the appliance cover with the heater at the
bottom.
» Click the heater into place using the snap fastener.
» Secure the appliance cover with the cover fixing
screws.
Tap installation
» Install the tap. For this, also observe the tap operat-
ing and installation instructions.
Material losses
!
» When making the connections, counter the
torque on the appliance using a size 14 spanner.
Pressure-tested tap
Note
» Fit the 3/8 connection hose provided and the 3/8
tee.
36


10.2.2 Oversink installation, non-pressurised, with
non-pressurised tap
Tap installation
» Install the tap. For this, also observe the tap operat-
ing and installation instructions.
Material losses
!
» When making the connections, counter the
torque on the appliance using a size 14 spanner;
see chapter "Installation alternatives / Under-
sink installation".
Appliance installation
» Fit the appliance to the tap with the water
connections.