Xylem LOWARA AQUAVAR IPC Schnellstartanleitung Seite 9

NOTICE:
Never operate a unit unless safety devices are
installed. Also see specific information about
safety devices in other chapters of this manual.
Electrical connections
Electrical connections must be made by certified
electricians in compliance with all international, na-
tional, state, and local regulations. For more infor-
mation about requirements, see sections dealing
specifically with electrical connections in the manual.
See QR code on front page for more information.
Precautions before work
Observe these safety precautions before you work
with the product or are in connection with the prod-
uct:
• Provide a suitable barrier around the work area,
for example, a guard rail.
• Make sure that all safety guards are in place and
secure.
• Make sure that you have a clear path of retreat.
• Make sure that the product cannot roll or fall over
and injure people or damage property.
• Make sure that the lifting equipment is in good
condition.
• Use a lifting harness, a safety line, and a breath-
ing device as required.
• Allow all system and pump components to cool
before you handle them.
• Make sure that the product has been thoroughly
cleaned.
• Disconnect and lock out power before you serv-
ice the pump.
• Check the explosion risk before you weld or use
electric hand tools.
Precautions during work
Observe these safety precautions when you work
with the product or are in connection with the prod-
uct:
• Never work alone.
• Always wear protective clothing and hand protec-
tion.
• Stay clear of suspended loads.
• Always lift the product by its lifting device.
• Beware of the risk of a sudden start if the product
is used with an automatic level control.
• Beware of the starting jerk, which can be power-
ful.
• Rinse the components in water after you disas-
semble the pump.
• Do not exceed the maximum working pressure of
the pump.
• Do not open any vent or drain valve or remove
any plugs while the system is pressurized. Make
sure that the pump is isolated from the system
and that pressure is relieved before you disas-
semble the pump, remove plugs, or disconnect
piping.
• Never operate a pump without a properly instal-
led coupling guard.
1.3.1 Wash the skin and eyes
Follow these procedures for chemicals or haz-
ardous fluids that have come into contact with
your eyes or your skin:
Condition Action
Chemicals or 1. Hold your eyelids apart for-
hazardous cibly with your fingers.
fluids in eyes 2. Rinse the eyes with eye-
wash or running water for
at least 15 minutes.
3. Seek medical attention.
Chemicals or 1. Remove contaminated
hazardous clothing.
fluids on skin 2. Wash the skin with soap
and water for at least 1 mi-
nute.
3. Seek medical attention, if
necessary.
1.4 Protecting the environment
Emissions and waste disposal
Observe the local regulations and codes regarding:
• Reporting of emissions to the appropriate author-
ities
• Sorting, recycling and disposal of solid or liquid
waste
• Clean-up of spills
Exceptional sites
CAUTION: Radiation Hazard
Do NOT send the product to Xylem if it
has been exposed to nuclear radiation,
unless Xylem has been informed and ap-
propriate actions have been agreed
upon.
Recycling guidelines
Always follow local laws and regulations regarding
recycling.
Waste and emissions guidelines
Do not dispose of equipment containing electrical
components together with domestic waste.
Collect it separately in accordance with local and
currently valid legislation.
1.5 EU declaration of conformity (No LVD/
EMCD31)
1. Apparatus model/ → data plate
Product:
2. Name and address Xylem Service Italia S.r.l.
of the manufacturer:
Via Vittorio Lombardi 14
36075 Montecchio Maggiore
VI
Italy
3. This declaration of conformity is issued under the
sole responsibility of the manufacturer.
4. Object of the dec- Frequency converter (varia-
laration: ble speed drive) AQUAVAR
IPC for electric pump in one
of the following models.
→ Annex I
en - Original instructions
9